25' Lag Switch for PS5, PS4, PS3, Xbox One & PC [Foot Button] Cat5e & 1gbps

Description

This lag switch is a 25' foot long Cat5e cable with a momentary button installed into the middle of the cable.
From one RJ45 connector to the lag box is approximately 12.25ft.
Foot-activated button design allows for more seamless use while also removing the need for bulky lag boxes and ethernet cables being taped/velcroed to your controller.
The cable used is premium Remee Cat5e 24AWG UTP and has booted RJ45 jacks to prevent snags. Requiring a commercial vendor, this superior cable provides a guaranteed 1gbps bandwidth and less crosstalk than cheaper alternatives.
Proper network set-up below:
Modem or Router (depending on source of internet) -> Lag Switch -> Powered Network Switch -> Ethernet Cable -> Xbox360/One/SeriesX,PS2/PS3/PS4/PS5,PC
Every powered network switch I have tested has worked perfectly but with that said -
I can not guarantee your setup will function properly as this will depend on your specific setup/device/game. Please make sure you've done your own research.
I personally use a Netgear G605v5 which can usually be found under on eBay.
Note - You will need to buy a network switch to use the lag switch properly. No where in the description does it say to connect this directly into your Xbox360/One/SeriesX/PS3/PS4/PS5/PC. If you connect this directly to your
Xbox360/One/SeriesX/PS3/PS4/PS5/PC
it will immediately disconnect you. Please refer to the picture gallery for a visual diagram.
Have any questions, issues, or a suggestion? Send a message!
Need a custom lag switch? Longer cable? Shorter cable? Send a message!